Before & After Photos

The problem

The attic of Mr Gaudio's house was very poorly insulated. It had about 6 inches of fiberglass as insulation, which is far from sufficient in Quebec. Because of this, he felt some very cold breezes in winter, especially in the rooms of the house and he had noticed that heating costs were getting very high.

The solution

We removed or customer's old insulation to properly seal any air leaks on the attic floor. Subsequently, we added our SilverGlo insulation boards on some walls of the attic to finally blow 16 '' of cellulose fibers.

PROBLEM

Winter is almost over. However, there has been an excess of drafts in the house, which was uncomfortable. Additionally, the Hydro bills were very high, especially during the months of December, January, and February due to the overuse of heating systems to compensate for the drafts. Consequently, the client does not want to repeat the same scenario next winter. During our free inspection, our specialist Dan examined the attic. He immediately noticed the inadequate amount of insulation. Furthermore, upon seeing the ventilation ducts, Dan identified a sealing issue.

SOLUTION

Our team of workers, led by Colin, began by removing the old insulation. This step is important because many holes allowing air to escape may be hidden underneath. They then conducted an extremely detailed inspection to identify, without exception, all sources of air leaks. Our excellent product ZypFoam is used to seal air leaks. As for the attic access hatch, it is the largest existing hole in the attic that can allow air to escape, hence the importance of insulating it very well. For this purpose, we used our revolutionary thermal insulation, SilverGlo. Finally, we blew in approximately 17 inches of TruSoft cellulose fiber insulation on the attic floor to achieve an optimal thermal value of R60.

During an attic insulation job, we encountered extreme humidity levels that had caused mold spores to develop within the old insulation. Our team removed the damp, contaminated insulation and thoroughly treated the area to eliminate all mold spores. Once the attic was properly cleaned and sealed, we installed our TruSoft cellulose insulation, achieving a thermal value of R60. This not only enhanced the home's energy efficiency but also addressed the moisture issue, creating a more comfortable and healthier environment for the homeowners.

Mr. Leduc contacted Systèmes Éconergie because he wanted to re-insulate his attic. He did well because his attic was very poorly insulated. In some places there were only 5 in’’ of fiberglass!

We removed the old insulation, sealed all air leaks, insulated the access hatch and blew 16” of cellulose fiber to achieve an R-60 value.

The problem

The lack and the  poor insulation of Mr. Robinson's attic made the rooms in his house very uncomfortable. He also noticed that the energy costs were getting higher, way more than the previous years. He therefore contacted Systèmes Éconergie for a free estimate.

The solution

Our team of experts removed the old insulation to seal all air leaks on the floor such as the joints between the boards. They insulated the access hatch and blew 16” of cellulose fibers to have an R-60 value.

With this solution, Mr. Robinson will be able to regain the comfort of his home and will have less energy costs.